Upgraded wetted materials and seals for corrosive and reactive gases, where the standard stainless path is not appropriate.
Request a quotation| Model | Type | Full-scale range | Process connection | Pressure drop (air to atmosphere) | Operating pressure |
|---|---|---|---|---|---|
| PFU-100SLPM-D | Corrosion-resistant gas mass flow controller | 0 – 100 SLPM | 1/4" NPT female | 2.5 PSID | 11.5 – 160 PSIA |
| PFU-250SLPM-D | Corrosion-resistant gas mass flow controller | 0 – 250 SLPM | 1/2" NPT female | 2.4 PSID | 11.5 – 160 PSIA |
| PFV-5SLPM-D | Corrosion-resistant gas mass flow controller | 0 – 5 SLPM | 1/8" NPT female | 2.0 PSID | 11.5 – 160 PSIA |
As a rule of thumb, size the instrument so your working flow falls between roughly 30% and 90% of full scale — well above the bottom of the range, where resolution is poor, and below the top, where the pressure drop figure quoted here applies. Instrument calibration is gas-specific: tell us the gas you are metering and we will confirm whether the published range applies directly or needs a correction.
Models in this series: PFU-100SLPM-D, PFU-250SLPM-D, PFV-5SLPM-D.
Tell us the gas, the flow you need to control or measure, and the pressures either side of the instrument. We will size it and quote it.
Request a quotation