DONGDE YUNHAIAlicat Flow Instrument Specialists
PFT high-pressure controllers

PFT-50SLPM-D
High-pressure gas mass flow controller — 0 – 50 SLPM

PFT-50SLPM-D is a high-pressure gas mass flow controller covering 0 – 50 SLPM, with — process connections, — pressure drop at full scale and an operating pressure range of 11.5 – 320 PSIA.

Request a quotation

Specification

ModelPFT-50SLPM-D
TypeHigh-pressure gas mass flow controller
Full-scale range0 – 50 SLPM
Process connection—
Pressure drop (air to atmosphere, full scale)—
Operating pressure11.5 – 320 PSIA

What this range covers

pilot-scale duty — small process lines, multi-channel test rigs, burners and bioreactor aeration where the working flow reaches tens or low hundreds of standard litres per minute.

Pressure drop for this unit is not published in the range table — confirm it against your line pressure before ordering; on low-range units the restriction is what decides whether the meter will work on your supply.

As a rule of thumb, size the instrument so your working flow falls between roughly 30% and 90% of full scale — well above the bottom of the range, where resolution is poor, and below the top, where the pressure drop figure quoted here applies. Instrument calibration is gas-specific: tell us the gas you are metering and we will confirm whether the published range applies directly or needs a correction.

Before you order — three things to confirm

  1. The gas. Calibration follows the gas you name. Reactive, corrosive or gas-mixture duty may need different wetted materials and seals — tell us the composition.
  2. The pressures either side. The pressure-drop column is measured to atmosphere at full scale. If your downstream pressure is above atmosphere, the usable span shifts; give us upstream and downstream pressure and we will confirm whether PFT-50SLPM-D still fits.
  3. The connection. This unit is supplied with —. Check your mating fitting and tube size before ordering — an adaptor changes both the dead volume and the effective restriction on low-range units.

Other models in the PFT high-pressure controllers

ModelTypeFull-scale rangeProcess connectionPressure dropOperating pressure

See the full PFT high-pressure controllers table or compare all 37 ranges.

Need this model quoted?

Send the gas, the flow you need to measure or control, and the pressures either side of the instrument. We will confirm the range and quote it — normally the same working day.

Request a quotation